Atv snatch blocks12/13/2023 ![]() If you are pulling your own vehicle, then you have to run the cable through the snatch block and then bring it back to your own vehicle. A double line pull requires using the snatch block to divert the cable back towards the winch. This one is for the situation where you will need to pull a vehicle heavier than the winch can pull or is bigger than your vehicle. However, it also cuts the pulling speed and makes it slow. The double line pull generates double pulling power for your winch. Here the snatch block diverts the cable at a proper angle to reach the offset anchor point. You should use a choke chain to attach the snatch block to the second anchor point.Īt last, use the tension the two offset anchor point creates to position the block in front of the vehicle in a direct way. Then you have to find another offset anchor point in the opposite direction as the first anchor point. For that, you have to run the cable through the snatch block to an offset anchor point. When you don’t have that privilege, you can use the snatch block for an angled single line pull. This situation can create the problem of gathering most of the cable on any one side of the winch drum.įor a straightforward anchor point winching is easy. However, sometimes you can face the problem of pulling at an angle. This is always the case when you are winching in a straightforward position. One of the basic rules for winching is to make sure that the cable rolls up on the winch drum evenly. One is for an offset anchor point and another one is for double line pull. You can use a snatch block for two types of winch rigging. For recovering vehicles, the swing block is the most commonly used snatch block among these three types. ![]() Those are snatch block with hook, snatch block with shackle and swing block. We can say that there are 3 types of snatch blocks based on the design and mechanism. Snatch Block Typesĭepending on design, size and uses, many different categories of snatch block exist. Second, it increases the pulling power of your winch by almost 2 times. It has mainly two jobs.įirst, it helps in changing the direction of the cable when you have an offset anchor point. It saves you the hassle of trying to thread your winch cable through the opening. It has a side plate that swings open to put the winch cable over the pulley. So, you can easily guess that it is used for pulling jobs. A snatch block is simply one kind of pulley block.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |